Carlos, We are a CLEC, and we have an ICA with ATT, this was regarding adding additional LATAs and ILECs to our network. -Eric On Thu, June 16, 2011 9:29 pm, Carlos Alcantar wrote:
Eric,
You will pretty much get stopped at the door with out being a clec without an ICA. You can't even get some of the required codes from telcordia and neustar without showing your proof of being a state regulated utility. There are a bunch of steps that need to happen before you can get to the point of doing local interconnect.
Carlos Alcantar Race Communications / Race Team Member 101 Haskins Way, So. San Francisco, CA. 94080 Phone: +1 415 376 3314 Fax: +1 650 246 8901 / carlos *at* race.com / www.race.com
On 6/16/11 4:12 PM, "Eric Hiller" <clec at cygnustel.com> wrote:
Carlos,
But what if you were in a LATA where ATT is and you have no ICA with ATT just some other ILEC in the LATA? Are you saying that ATT would not allow you to port any numbers from them without an ICA?
-Eric
On Thu, June 16, 2011 5:30 pm, Carlos Alcantar wrote:
Eric,
We just went through this battle with att we thought the same but reading deep into our ICA we had to get minimum trunks to all the tandems in the lata 2x t1's and then we ordered the majority of our trunking at the tandem where we homed our LRN. It sucks but we haven't found a way around it.
Carlos Alcantar Race Communications / Race Team Member 101 Haskins Way, So. San Francisco, CA. 94080 Phone: +1 415 376 3314 Fax: +1 650 246 8901 / carlos *at* race.com / www.race.com <http://www.race.com/>
On 6/16/11 2:02 PM, "Eric Hiller" <clec at cygnustel.com> wrote:
I would not think you would need trunks to all the tandems in the lata for TERMINATIONS though, just ORIGINATIONS as Mary Lou had said?
For example I can port a number from Level 3 even though I am not on every tandem in the LATA now.
Is this correct Mary Lou? So if I added 4 new LATAs and I just wanted to do terminations, I would just have to establish a new LRN in each LATA as well as trunking to the tandem my LRN is homed on?
-Eric
On Wed, June 15, 2011 5:59 pm, Carlos Alcantar wrote:
Mary Lou,
At least here in CA att makes you trunk to all the tandems in the lata. At least with min trunks and you build your bulk of your trunks where your LRN is going to sit at.
Carlos Alcantar Race Communications / Race Team Member 101 Haskins Way, So. San Francisco, CA. 94080 Phone: +1 415 376 3314 Fax: +1 650 246 8901 / carlos at race.com / www.race.com <http://www.race.com/>
On 6/15/11 10:55 AM, "Mary Lou Carey" <marylou at backuptelecom.com> wrote:
To terminate traffic you only need to have trunking to the LRN tandem in that LATA, but to originate traffic you need to have trunking established to the tandem that the rate center of the NXX homes on. Once we have all your Chicago trunks installed, you will be able to port any number in the LATA to yourself. Make sense?
Mary Lou Carey BackUP Telecom Consulting CLEC Consultant OFF: 615-791-9969
-----Original Message----- From: voiceops-bounces at voiceops.org [mailto:voiceops-bounces at voiceops.org] On Behalf Of Eric Hiller Sent: Wednesday, June 15, 2011 10:50 AM To: voiceops at voiceops.org Subject: [VoiceOps] Porting Number - CLEC
In order to port a number, what trunking requirements do we have? Is it that we have to have trunking to the same tandem as the npa-nxx holder? IE. If I wanted to port 100-100-1000 And the 100-100-1 thousands block is held by company A, and then 100-100 npanxx/ten k block is held by Company B and is homed on Tandem C, then I just need to have trunking into Tandem C and have an ICA with whomever controls Tandem C, which could be company A,B or some third company C correct?
The same would apply in order to get our own thousands block as well correct?
Thanks, -Eric Hiller Cygnus
_______________________________________________ VoiceOps mailing list VoiceOps at voiceops.org https://puck.nether.net/mailman/listinfo/voiceops
_______________________________________________ VoiceOps mailing list VoiceOps at voiceops.org https://puck.nether.net/mailman/listinfo/voiceops