Take an old IP phone and clip the speaker wire ? connect the speaker wire to your audio pairs? you can daisy chain to all of them Put a screw or tape the hookflash down Set your page key up to intercom call that IP phone Cheapest way I know. Regards, Jake Clappton Intelecom, Inc / voipdesk 925.701.3008 - Direct 925.846.8025 - eFax www.voipdesk.com<http://www.voipdesk.com/> From: VoiceOps <voiceops-bounces at voiceops.org> On Behalf Of Darin Steffl Sent: Thursday, April 18, 2019 3:40 PM To: VoiceOps <voiceops at voiceops.org> Subject: [VoiceOps] Old PA System setup Hey guys, https://www.valcom.com/pdf/v1030c_v1036c.pdf We're trying to find the best way to interface 3 old Valcom speakers V-1030c to an IP paging system. I have a Snom PA1 but that won't work as we initially thought because speakers need 4 wires on a 24v power system. So 2 wires are for 24v power, and the other 2 are for audio. The snom only has a positive and negative output that feeds passive speakers, not active speakers like these. What is the best way to utilize these 3 speakers or should we just replace the speakers? We're trying to keep budget to a minimum for them so we would prefer to utilize the same speakers but what's the best way to power them and feed them audio using the existing 2-pair RJ11 cable they use? Thank you -- Darin Steffl Minnesota WiFi www.mnwifi.com<http://www.mnwifi.com/> 507-634-WiFi [http://www.snoitulosten.com/wp-content/uploads/2010/01/facebook-small.jpg]<http://www.facebook.com/minnesotawifi> Like us on Facebook<http://www.facebook.com/minnesotawifi>