Hi Jason, Asterisk 1.6.1.6 is the software that am using and it supports SS7. Warm Regards Venugopal G HNM-SO WiMAX CPE VoIP IOT Team Cell : +91-99723-99437 ************************************************************************ ************************************************************************ ************************************************* -----Original Message----- From: Jason Vanick [mailto:jvanick at spruce.oaknet.com] Sent: Thursday, November 12, 2009 8:26 PM To: Gopalakrishnaiyer Venugopal-Q16770 Cc: voiceops at voiceops.org Subject: Re: [VoiceOps] PSTN connection to SONUS Actually you'll probably want to use a PRI config ISUP is used if you're connecting to a switch that requires SS7 signalling. as far as I'm aware, asterisk doesn't support SS7. you'll need to use the Sonus EMS Task Configurator to build a PRI trunk group this should be all covered in the online help. Make sure you set the "Switch Side Behavior" to Network and set a switch type that matches what you set the Asterisk configuration to. --J
Hi Jason=20
Thanks for the information that you gave. I want to connect to an Asterisk PBX which will act as the termination. So I guess I should be
using an ISUP connection. Also I will be using an E1 to connect the same.
Warm Regards Venugopal G ********************************************************************** ** ********************************************************************** ** ************************************************* =20
-----Original Message----- From: Jason Vanick [mailto:jvanick at spruce.oaknet.com]=20 Sent: Thursday, November 12, 2009 8:01 PM To: Gopalakrishnaiyer Venugopal-Q16770 Subject: Re: [VoiceOps] PSTN connection to SONUS
There are different procedures based on what kind of trunk you want to
add...
is it ISDN PRI, Is it ISUP, is it CAS etc...=20
What kind of circuit are you planning? DS1, DS1 on DS3, or optical?
this should be all covered in the manuals.
It's not an extremely involved, but you do need go get the steps done in the correct order.
-J
I have a SONUS GSX9000 chassis.I want to add PSTN connection to this=20 SONUS.I am new to the switch background.Does anyone have the
procedure
to add a PSTN connection to the SONUS Switch =20 =20 Warm Regards Venugopal G