Done it many times, but it really isn't anything specific to BroadWorks except for remembering to be careful about allowing calls from the outside in anyway (think telemarketers and wrong numbers over the PA). We usually just didn't give that user a DID. Normally we used an ATA or IAD coupled with a line controller (usually the V-9970: http://www.valcom.com/pdf/v-9970.pdf), and tell the customer that from there (amps and speakers/horns as well as wiring) it is the responsibility of their paging vendor. I've also worked with Bogen systems that had an integrated line controller, but that one expected an FXO handoff so we had to use a different CPE device. It was also a much higher end system than any of the Valcom setups I have seen. If you need to know anything more specific feel free to ask, but to me the PA side of the systems is a whole different game I'd much rather stay out of. -Scott From: voiceops-bounces at voiceops.org [mailto:voiceops-bounces at voiceops.org] On Behalf Of Dawson, Robert Sent: Monday, November 29, 2010 4:58 PM To: VoiceOps at voiceops.org Subject: [VoiceOps] Broadworks/Valcom paging solution Anyone out there have experience with Valcom paging solutions on Broadworks? This would be a simple application - 1 zone and 2 horns. Any recommendations for other products?